ANATOMICAL CALIBRATION PROTOCOL

ANATOMICAL CALIBRATION PROTOCOL

To ensure your silhouette is engineered correctly, stand in a natural upright position and follow these specific movement cues.

SUPERIOR AXIS (Upper Body)

  • Neck: Measure around the base of the neck, just below the Adam’s apple. Keep one finger between the tape and your skin for comfort.
  • Neck to Shoulder: Start at the base of the neck and follow the top of your shoulder out to the sharp edge of your shoulder bone.
  • Armscye: Loop the tape vertically around your shoulder, passing directly through the center of your armpit and over the top of the shoulder joint.
  • Bicep: Flex your arm and measure the widest part of the muscle.
  • Wrist: Measure around the narrowest part of your wrist, directly over the bony bump.
  • Arm Length: Place the tape at the edge of your shoulder bone, run it down the outside of your arm, over a slightly bent elbow, and end at your wrist bone.
  • Chest: Wrap the tape under your arms and around the widest part of your chest. Keep the tape level with the floor and your shoulder blades relaxed.

CENTRAL ARCHITECTURE (Torso)

  • Waist: Measure around your torso at the narrowest point (usually an inch above your belly button). Do not suck in your stomach; breathe out naturally.
  • Hip/Seat: Wrap the tape around the widest part of your buttocks. Ensure the tape remains perfectly horizontal to the floor.
  • Back Length: Start at the prominent bone at the very base of your neck and measure straight down your spine to your natural waistline.
  • Total Rise: Place the tape at the center-front of your waistband, run it down between your legs, and pull it up to the center-back of your waistband.
  • Torso Loop: Start at the midpoint of your shoulder, run the tape down your front, through your crotch, and back up your spine to the same shoulder point.

INFERIOR AXIS (Lower Body)

  • Inseam: Start at the highest point of your inner thigh (the crotch) and measure down the inside of your leg to the center of your ankle bone.
  • Outseam: Start at your waistline on the side of your body and measure straight down the outside of your leg to your ankle bone.
  • Thigh Girth: Measure around the widest part of your upper thigh, approximately two inches below the crotch.
  • Leg Girth (Calf): Wrap the tape around the thickest part of your calf muscle.

·        Calf Girth: Measure around the thickest, most muscular part of your lower leg. For the most accurate reading, stand with your weight distributed evenly on both feet and ensure the tape is level with the floor.


ATELIER CALIBRATION NOTES

  • Static Tension: The tape should sit flat against the skin like a second skin. Do not pull it tight enough to indent the flesh.
  • Mirror Verification: Use a mirror to ensure the tape does not sag or twist, especially across your back and glutes.